3upplemental Support Disk for installing from a PCMCIA source
-------------------------------------------------------------

This is a version of the pcmcia disk for use with Linux 2.4.33.3 bootdisks.

WARNING!  This is not a stand-alone installation disk.  You will also need the
install rootdisks to install from a PCMCIA source.  Do not write protect the
supplemental PCMCIA support disk.

1.  Boot the bare.i bootdisk.  This uses a generic IDE kernel and is the
    correct bootdisk to use when installing Slackware Linux on a laptop.

2.  When prompted, load the install rootdisks starting with install.1.
    These are the main installation disks.

3.  After you're logged into the system with the username "root", you start
    the PCMCIA support system with the command "pcmcia".  Then you'll be
    prompted to take these actions:

    o   Insert the pcmcia.dsk support floppy
    o   Attach your PCMCIA/Cardbus devices if they are not already attached.
    o   Remove the pcmcia.dsk support floppy

4.  Now you're ready to proceed with the installation as usual.  If you
    need to partition your drive with "fdisk" or "cfdisk", do that first,
    otherwise go ahead and run "setup".